Volume 2, Issue 1, March 2018, Page: 1-7
Effect of Pollution on Mechanical Properties of Foundations in Towers of Electrical Transmission
González Rolón Bárbara, Mechanical Engineering Department, Faculty of Engineering University of Guanajuato, Salamanca, Mexico
Fuentes Castañeda Pilar, Mechanical Engineering Department, Faculty of Engineering University of Guanajuato, Salamanca, Mexico
Received: Feb. 27, 2018;       Accepted: Mar. 21, 2018;       Published: Apr. 18, 2018
DOI: 10.11648/j.ajmme.20180201.11      View  640      Downloads  60
The effect of meteorological variables such as relative humidity, maximum temperature, and predominant wind orientation, as well as oxidant species on the variation of mechanical resistance to compression of the cylinders extracted from two electric transmission towers was investigated. The obtained results are compared with the mechanical strength to compression achieved in concrete cylinders prepared in the laboratory and submerged in solutions of nitric acid and sulfuric acid in concentrations taken from the statistical data of nitrous oxide and sulfurous present in the environment where have installed the towers under study. The results show a decrease in the mechanical strength of the exposed cores in the predominant direction of the wind and of the cylinders submerged in the solution with acids, concluding that both conditions favor the degradation of concrete properties.
Concrete Cylinders, Mechanical Strength, Meteorological Variables, Pollution, Transmission Towers
To cite this article
González Rolón Bárbara, Fuentes Castañeda Pilar, Effect of Pollution on Mechanical Properties of Foundations in Towers of Electrical Transmission, American Journal of Mechanical and Materials Engineering. Vol. 2, No. 1, 2018, pp. 1-7. doi: 10.11648/j.ajmme.20180201.11
Copyright © 2018 Authors retain the copyright of this article.
This article is an open access article distributed under the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/) which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
S. Talukdar, N. Banthia, et al. “Carbonation in concrete infraestructura in the context of global climate change”: Part2-Canadian urban simulations. Cem. Concr. Compos. 34 (2012), pp. 931-935.
P. F. Marques, C. Chastre, et al. ”Carbonation service life modelling of RC structures for concrete with Portland and blended cements.” Cem. Concr. Compos. 37 (2013), pp. 171-184. DOI: S095894651730639X
M. G. Alexander, J. R. Mackechnie, et al. ”Carbonation of concrete bridge structures in three South African localities.” Cem. Concr. Compos. 29 (2007), pp. 750-759. DOI: S0950061809003584
F. J. L. Molina, M. C. A. Alonso, M. S. Moreno & R. J. Centenero, “Corrosion protection of galvanized rebars in ternary binder concrete exposed to chloride penetration”. Construction and Building Materials, 156, (2017) pp 468-475.
G. Blackett, E. Savory, et al. “An evaluation of the environmental burdens of present and alternative materials used for electricity transmission.” Build. Environ. 43(2008), pp. 1326-1338. DOI: S1877705812028081
R. Aaron R. Grubbs, Adam C. Carroll, Anton K. Schindler, and. W. Robert Barnes. Evaluation of IN-Place Concrete Strength by Core Testing, Research Report No. 2 for AIDOT project 930-828-2, (2016) pp 12, 22.
ASTM International 2007 FORTY_FOURTH Edition STOCK Number; BLD607, C-42/C 42M-04: “Obtaining and testing drilled cores and sawed beams of concrete”, Vol. 1 (2007) pag. x.
American Society for Testing and Materials, C-39: “Compressive strength of cylindrical concrete specimens,” ASTM, United States 2003.
S. A Ghahari, A. Mohammadi, A. A Ramezanianpour Performance Assessment of Natural Pozzolan Roller Compacted Concrete Pavements. Case studies in construction Materials Vol. 7, (2017) pp. 82-90.
P. C. Borges, “Corrosión en estructuras de concreto armado” Teoría, inspección, diagnóstico, vida útil y reparaciones, IMCYC (2001) 46 pp. (in Spanish).
M. Thomas. “The effect of supplementary cementing materials on alkali-silica reaction”: A review. Cem. Concr. Res. 41 (2011), pp. 1224-1231.
S. H. Kosmatka, B. Kerkhoff, et al. “Diseño y control de mezclas de concreto,” Portland Cement Association (2004) 6 pp. (in Spanish).
D. P. Cerqueira, K. F. Portella, et al. “Deterioration rates of metal and concrete structures in coastal environment of the South and Northeast Brazi”l: case studies in the Pontal do Sul, PR, and Costa do Sauípe, Bahia. Procedia Eng. 42 (2012), pp. 384-396.
Fundación Guanajuato Produce A. C., Guanajuato-Exportar datos de la red de estaciones, http://www.estaciones.fundacionguanajuato.mx/export/, (2016) (in Spanish).
Instituto de Ecología del Estado de Guanajuato, “Programa de Gestión de Calidad para Mejorar la Calidad del Aire de Salamanca, Celaya e Irapuato 2013-2022”, SEMARNAT. (2013) 42, 44, 46, 48 pp. (in Spanish).
H. H. Uhlig, “Corrosion and Corrosion Control,” 3rd ed., vol 1, Ed. R. W. Revie Wiley-Interscience, New York 1985. Pp. 229-231.
D. A. Jones, “Principles and Prevention of Corrosion,” Mc. Millan 2nd ed. 1992. pp. 388-389.
A. Valle, T. Pérez, et al. ”El fenómeno de la corrosión en estructuras de concreto reforzado,” SCT-Instituto Mexicano del Transporte. (2001) 40 pp. (in Spanish). DOI: S0718-50732009000300004
Browse journals by subject